Cool Rear End Cover Idea

[cbfomoco]

I was searching ebay and ran across a GMC dump truck that I was looking at the hoist on. ( I am wanting a dump bed and have been looking at all the different set ups. ) Anyway This truck had a cool rear end cover. I would love for someone to make one of these for fords with Ford script. And Also for front ends as well. If Anybody knows of one let me know.

[fordman]

i think they do make then and in chrome too. maybe. they would only fit the ford dana though. that is some good old style script on that one though.

[cep62]

Check out  moltenimagedesign.com  

they have some that'll scare ya  (with price and design)

[Joshpow]

Get good with a welder, and you may be able to put a logo on a 9  inch!  That'd be cool.  Just weld on the back of the rearend where a pan would be on other axles.

[fordman]

i could possibly do it with a stick welder. maybe a wire welder.

[Skifu]

That would probably warp the cover,(welding)maybe not,that is a tough old 12 bolt on that GMC.

[1971ford]

^ that's what i was going to say.
Welding on a cover will most likely warp it and it will be hard to get it to seal right. Be careful

[ForingaMex]

If we're talking about welding on a 9 inch you don't need to wory about warping or sealing. The rear cover is already welded to the axle housing. Or did I mis something?

Jake

[marxtoys]

I want one just like the pic.....



..... for a Dana 70.

[Fordnatic]

Yes, the 9" cover is welded on, can't hurt it by welding more on it.  The gears and carrier come out the front on a 9" Ford rear, one of it's greatest advantages.

[1971ford]

Yes, the 9" cover is welded on, can't hurt it by welding more on it.  The gears and carrier come out the front on a 9" Ford rear, one of it's greatest advantages.

You're right, i thought the topic was just about rearends like the Dana 60 that have a removable rear cover